Can anyone tell me why sometimes (before they set themselves) the 2 ABS lights flash together and sometimes alternately? Does it matter?
Is there a light for each unit? if so which is which?
Just curious.
Thanks. Harry.
ABS console lights
Moderators: slparry, Gromit, Paul
-
Paul
- Wanna buy a sticker mister?
- Posts: 2906
- Joined: Mon Feb 16, 2004 8:44 pm
- Location: Boxertrix Towers, Norfolk
- Contact:
Harry,
Alternating means all is fine. Both together means a fault has been detected. Sometimes if the battery is not fully charged, the system goes straight into fault mode, but it's usually OK if you run the engine for a minute or two, turn it off and try again.
Cheers,
Paul
Alternating means all is fine. Both together means a fault has been detected. Sometimes if the battery is not fully charged, the system goes straight into fault mode, but it's usually OK if you run the engine for a minute or two, turn it off and try again.
Cheers,
Paul
You really need only two tools: WD-40 and duct tape. If it doesn't move and it should, use WD-40. If it moves and shouldn't, use the tape.