starter motor cover

boxerpan · Post by **boxerpan** » Sat Mar 25, 2006 2:22 pm

...how is it attached ? Allen bolt ? What size ?

theseadog · Post by **theseadog** » Sat Mar 25, 2006 2:38 pm

From memory Lloyd it's a single alen head bolt that holds it on, as you look at the cover from the side the bolt is towards the middle of the bike about half way up the cover. Size 5.

HTH

Toodle Pip

Jason M · Post by **Jason M** » Sat Mar 25, 2006 5:12 pm

boxerpan wrote:...how is it attached ? Allen bolt ? What size ?

Yep... a single 5mm hex - not the easiest thing to get at unless you have some ball headed hex sockets (as I do)

Jason

boxerpan · Post by **boxerpan** » Sat Mar 25, 2006 8:38 pm

Jason M wrote:
boxerpan wrote:...how is it attached ? Allen bolt ? What size ?
Yep... a single 5mm hex - not the easiest thing to get at unless you have some ball headed hex sockets (as I do)

Jason

I do. Is it thru thr small hole at the back of the cover by the gear shift arm ?

madman · Post by **madman** » Sat Mar 25, 2006 9:14 pm

If you put your fingers round the back of the cover you can feel it. You can just about see it if you look through the gap above the swinging arm povot.

bigblackfalco · Post by **bigblackfalco** » Sun Mar 26, 2006 12:18 am

rip it off man....tis for pussies!
Bailey.

www.boxertrix.com

starter motor cover

starter motor cover

Re: starter motor cover

Re: starter motor cover