Page 1 of 1
K&N Filters ?
Posted: Fri Oct 13, 2006 10:02 am
by cc mac
I noticed a supplier on Ebay making claims of performance improvement with these filters. Does this work at all / in conjunction with induct kits / or not at all ? My bike is standard at present including cat, though that might be replaced with a Y piece if the bolts can't be replaced when I get the clutch done.
Posted: Fri Oct 13, 2006 6:50 pm
by winger
Extra performance??? i doubt it but certainley makes the throttle more responsive,but your getting ahead of yourself if you've still running the bike with a cat,i'd be more concerned about a Y piece.
Posted: Fri Oct 13, 2006 9:42 pm
by iandunn1100ss
I have a spare k&n if you want one.
Posted: Sat Oct 14, 2006 5:16 pm
by cc mac
The cats got to come off for the clutch job. It's possible that the cat bolts will snap and rather than pay the mechanic to drill them out and re tap, it might be worth fitting the Y piece at this point. Is it worth the extra outlay ?
Also would I need to make any further mods because of the Y piece.
Posted: Sat Oct 14, 2006 5:24 pm
by Gromit
cc mac wrote:It might be worth fitting the Y piece at this point. Is it worth the extra outlay ?
Yes.
cc mac wrote:
Also would I need to make any further mods because of the Y piece.
No.
hth
Posted: Sat Oct 14, 2006 9:08 pm
by throttlemeister
I have a K&N in my bike, and it is pretty dirty, but I don't have the cleaning stuff and oil from K&N at the moment.
Can I clean it with petroleum/gasoline?
Is there other stuff you can oil it with that works?