Hello again. I hope you are all wonderful.
Trying to resurrect my old R1100S. I pulled the tank off and it looks like the previous owner had jammed in a 896 Lawnmower battery. after judicious hammertime of the battery tray. I ordered a similar replacement (Very Very Cheap) but it is frighteningly close to the bottom of the fuel tank.
Bike Starts and runs OK, But I suspect my input shaft Is on its way out. (rattly noise).
What is the correct battery for this bike? Motobatt 51814?
I need to decide whether to save or break it, as it has a set of remus pipes.
Cheers
Battery for early R1100S
Moderators: slparry, Gromit, Paul
Re: Battery for early R1100S
If the 896 is doing the job I'd just cover it ( the terminals ) with a piece of old inner tube to insulate it.... Other than that does your bike have Abs ? If so you'll need a 19 or 20A/h battery.
I've used a locally purchased Platinum ctm19lbs AGM battery which I laid on its side after modifying the battery box , (Abs removed)
I think I tried something similar to a 51814 a while back but it didn't turn over the engine very well ... I've since replaced the starter motor so maybe that was the problem?
I've used a locally purchased Platinum ctm19lbs AGM battery which I laid on its side after modifying the battery box , (Abs removed)
I think I tried something similar to a 51814 a while back but it didn't turn over the engine very well ... I've since replaced the starter motor so maybe that was the problem?
_________________
Nigel
Keep smiling, it makes people wonder what you've been up to!
1999 R1100s (mandarin) '
2018 DL 250V Strom
2019 CB125F Honda.
MZ301 Saxon Fun ( currently retired)
'03 Bullet 65 project..
Nigel
Keep smiling, it makes people wonder what you've been up to!
1999 R1100s (mandarin) '
2018 DL 250V Strom
2019 CB125F Honda.
MZ301 Saxon Fun ( currently retired)
'03 Bullet 65 project..
Re: Battery for early R1100S
Thank you.
I'll line everything up tomorrow. The bike has been sitting for 4 1/2 years so I need to bleed the brakes and do a bunch of other stuff before I take for MOT/ decide whether to part it out.
It's a non ABS model.
I'll line everything up tomorrow. The bike has been sitting for 4 1/2 years so I need to bleed the brakes and do a bunch of other stuff before I take for MOT/ decide whether to part it out.
It's a non ABS model.
Gary
Re: Battery for early R1100S
Bought the exide battery in the end. Bike is back together.
Thanks for the input.
Thanks for the input.
Gary