Page 1 of 1

Respraying fork legs

Posted: Fri Jun 03, 2016 10:54 am
by victorlaszlo
Hi all,

Thinking of doing up the fork legs on my R1100S and the paint normally recommended is the Wurth silver spray.

http://www.ebay.co.uk/itm/310383738142? ... EBIDX%3AIT

However, at £17 a bottle plus roughly the same for the clear coat is there any other, cheaper, but equally good and similar looking spray that anyone has used? Hammerite perhaps?

Ideally I'd like to find one that looks correct and doesn't require too much prep work or any top coat.

Thanks Victor

Posted: Fri Jun 03, 2016 11:10 am
by Pete.
I like Simoniz wheel silver. It's not too shiny or garish, and (not that it matters here) is also a very good match for silver-painted steel frames. I have used it to touch-up a CBR600 and a VFD1000 frame in the past and if you paint a whole section you'd find it very hard to tell.

Posted: Fri Jun 03, 2016 11:12 am
by victorlaszlo
And in terms of prep work and top coat, how is it to work with?

Posted: Fri Jun 03, 2016 11:37 am
by Merecat
Smootherite silver is what i used. I did fork legs and brace with 1 can and then a couple of coats of clear lacquer.

Here is the thread:

viewtopic.php?t=14712&postdays=0&postorder=asc&start=0

Mick

Posted: Fri Jun 03, 2016 12:05 pm
by victorlaszlo
Smotherite = Hammerite smooth? :)

Posted: Fri Jun 03, 2016 1:29 pm
by Merecat
victorlaszlo wrote:Smotherite = Hammerite smooth? :)
This:
https://www.amazon.co.uk/Hammerite-5084 ... B004Z4UMDW

Posted: Fri Jun 03, 2016 1:52 pm
by victorlaszlo
Merecat wrote:
victorlaszlo wrote:Smotherite = Hammerite smooth? :)
This:
https://www.amazon.co.uk/Hammerite-5084 ... B004Z4UMDW
That's the one I was considering - cheers mate!