Page 1 of 1
WANTED: R1100S Carbon Fibre valve covers
Posted: Wed Apr 06, 2016 3:16 pm
by Henners
Hi ~ if you have s set in good condition they would like to sell please PM me with price plus postage and a contact number. Thank you ~ Tom
Posted: Wed Apr 06, 2016 4:41 pm
by Blackal
Those are made from Unobtanium!
Is it single-spark or dual-spark?
You'd be better (cheaper) getting a pair of pattern items (have a search on Ebay) that are "close to original".
Al
Posted: Wed Apr 06, 2016 4:57 pm
by Henners
Thanks Al ~ been on eBay and can get them from USA ~ just a punt here to see if some are gathering dust anywhere in the Club
Posted: Wed Apr 06, 2016 5:06 pm
by Blackal
I'm sure the originals are out there (I have a "few" in the cupboard), but doubt if you are prepared to pay £300+ for a pair of them.............
Fine if you require originality for a BCR, but otherwise - a bit of an expense?
Al
Posted: Wed Apr 06, 2016 5:13 pm
by Blackal
Posted: Wed Apr 06, 2016 5:34 pm
by Henners
Blackal wrote:http://www.ebay.co.uk/itm/like/291456139292?clk_rvr_id=1010582829946&item=291456139292&lgeo=1&vectorid=229508&rmvSB=true
These?
Al
Unfortunately twin-spark and mine isn't
Posted: Thu Apr 07, 2016 12:06 am
by Mitch1100
Blackal wrote:http://www.ebay.co.uk/itm/like/291456139292?clk_rvr_id=1010582829946&item=291456139292&lgeo=1&vectorid=229508&rmvSB=true
These?
Al
They look good, priced ok, even without titanium sliders...might grab a pair and garage originals in case
