www.boxertrix.com

hi all,sadly had the misfortune to damage the r 1100 s decal/sticker on the offside valance of my bike, have managed to secure a replacement from germany but how to remove and replace the item, I've not done anything like this before so don't want to balls it up, any advice would be much appreciated cheers Chris

Many, many years ago I was unable to find a black crash helmet at the right price (not many pennies back then) but
there was one with stickers all over it, so got that one and used a hair dryer to remove them, with great success.

Hope this helps

Ned

Hello,

+1 for the hairdryer! Softens the glue allowing removal and then polish the area to get rid of any residual.

Best regards,

David

and when applying the new one fine water spray and a credit card as a squeegy to allow the new one to go in place without air bubbles

thanks for the info chaps,it was the water spray i wanted to hear as some decals don't use that method, thanks again

applied with fine water spray, factory finish, thanks

ceepee wrote:applied with fine water spray, factory finish, thanks

excellent! ... pictures man we need pictures

if i knew how to post pictures i would, we are still trying to develop the round wheel down here!!!!

Hi ceepee, where did you source the decals from as I've been trying to get one for a BCR. The ones from Britain were difficult to fit and as the German ones seem OK I might try them.

Hi Mel, i sourced the German decals from an on line site,can't remember which one, i think they cost about £40.00 ,but that seemed to be for two or at least they sent me two, the quality is first class as they seem to be factory items

Hi try this site

http://bit.ly/1foNLBI I've just orders a set
All the best Guy

I need a set for my boxercup which is the nearest blue to mine ? the repsol seems summat like