Page 1 of 1
old style OE bellypan
Posted: Sun Jan 30, 2005 7:13 pm
by boxerpan
Can ayone help with a copy of the exploded diagram/fitting instructions for the 4 piece c/f airdam or bellypan that BMW used to sell for the S ?
Posted: Sun Jan 30, 2005 7:24 pm
by LucaS
Try to give a look here, maybe you find something useful:
http://www.maxbmwmotorcycles.com/fiche/ ... del=R1100S
Ciao, Luca
Posted: Sun Jan 30, 2005 7:28 pm
by boxerpan
Luca,
that's the one, thank you for the link.
Posted: Sun Jan 30, 2005 7:55 pm
by adamski49
Lloyd
Just to help a little more:
Brackets 8 and 6 fix to the same point on the crankcase below the cylinders.
Bracket 9 fixes to the underside of the block where the cat retaining bracket fixes.
Bracket 7 fixes to the C frame, possibly at the rubber bump stop for the side stand (I'll have to go and look).
All these little allen bolts tighten to all of 7 Nm
HTH
Adam
Posted: Sun Jan 30, 2005 8:29 pm
by boxerpan
adamski49 wrote:Lloyd
Just to help a little more:
Brackets 8 and 6 fix to the same point on the crankcase below the cylinders.
Bracket 9 fixes to the underside of the block where the cat retaining bracket fixes.
Bracket 7 fixes to the C frame, possibly at the rubber bump stop for the side stand (I'll have to go and look).
All these little allen bolts tighten to all of 7 Nm
HTH
Adam
Many thanks, got to get some proper bolts from 'the man' before this can take full effect!
Posted: Mon Jan 31, 2005 10:03 am
by adamski49
Lloyd
Took the pics anyway.
The PIA brackets are the two under the cylinders and the front one as the CF has to come off to realign. I'm pretty sure the front one is horizontal. The two rear ones can be adjusted with the panels in place. Enjoy!
Adam