Page 1 of 1
Oxford heated grips - removal of!!
Posted: Sat Jun 23, 2012 12:07 pm
by brookes745
Anyone removed a set of Oxford heated grips without damaging them?
Posted: Sat Jun 23, 2012 12:16 pm
by simon
... no
Not really being facetious.. Have removed them, but damaged in doing so. I wanted shot of them, so wasn't bothered. Thought they looked awful, along with the control unit, and one side was slipping, and wasn't happy with the way they were plumbed in.
.. used a stanley knife.
Posted: Sat Jun 23, 2012 1:09 pm
by brookes745
simon wrote:
Thought they looked awful
My thoughts exactly.....I want shot of them but being a Yorkshireman, if I can get them off in one peice and flog them........
.....if not, like you, its out with the stanley knife...
Posted: Sat Jun 23, 2012 2:10 pm
by Britisherspy
I have got them off but they do get a bit damaged - still working though!
I have fitted and removed them 3 times so far!
Loads of wd40 and a thin round screwdriver + plenty of patience.
Posted: Sun Jun 24, 2012 9:00 am
by Me-109
Only by sawing the handlebars down and then sawing lengthways internally.