Out for a ride yesterday and the warning light came on. Oh f*** it what's it say in the manual - stop and summon help.
The bikes running OK and the brakes are working so what could it be?
Warning light was on last week when the bike had been stood for a few days and it was very cold stayed on until work and then went off when I switch off and on again must have been lack of charge in the battery. Not a year old yet and showing signs of imminent demise.
Anyway since it was running OK and I had done 50 miles it was probably not the battery this time so something much more serious? Stopped for the bacon sandwich and had a think - must be the lights then - one has failed - no they were all working.
Got home and pondered some more while cleaning all the filthy salt c**p off. Then I remembered the fiendishly clever electrics in the back light.
If the tail light goes the bike send a reduced voltage to the stop light but you can't tell this without taking the lamp out and looking at the filaments.
Don't panic
Moderators: slparry, Gromit, Paul
- bernsmartco
- Posts: 214
- Joined: Sat Feb 21, 2004 6:53 pm
- Location: Worcester
Don't panic
Ride safely
Bern.
Bern.
- Paul
- Wanna buy a sticker mister?
- Posts: 2905
- Joined: Mon Feb 16, 2004 8:44 pm
- Location: Boxertrix Towers, Norfolk
- Contact:
Which light Bern? The oil warning light? The switch/sensor for that is notoriously prone to water ingress, so if you've recently washed (or worse jet washed) around the oil sight glass on the engine that could be the problem.
If it's the ABS warning lights, could just be your battery being a bit low on charge, or you're not leaving a long enough time from ignition on to firing up the starter motor. If it's the weak battery, then riding around for five minutes then turning the engine off and back on generally works.
Cheers,
Paul
If it's the ABS warning lights, could just be your battery being a bit low on charge, or you're not leaving a long enough time from ignition on to firing up the starter motor. If it's the weak battery, then riding around for five minutes then turning the engine off and back on generally works.
Cheers,
Paul
You really need only two tools: WD-40 and duct tape. If it doesn't move and it should, use WD-40. If it moves and shouldn't, use the tape.