Boxercup head cover sliders

[dave the german]

As the subject suggests, if anyone has thought about fitting FF Carbon head covers, they don't come with the metal sliders. I'm looking at getting some made so if anyone is interested, let me know as there may be a minimum number order

[FAB]

Hi,
To Screw or to stick?

[dave the german]

they'll be to screw on as per originals. This has just raised a slight issue however as the original screw are very short. I do have a quantity but may have to source more if there are any interested parties or

[FAB]

You can not screw them with the original screws.
You need specific screws.

I am looking for covers to stick for track use.

[dave the german]

The parts I’m hoping to get made are the metal sliders which fit on the front lower corner of the carbon covers which are fitted to the Boxercup. They are screwed on from the inside of the carbon covers

[FAB]

Oooops,
Sorry for the misunderstanding.

[dave the german]

No problem. I didn't think there would be much demand for them but in order for the guy to make them profitable, I might have to get a small quantity made. I'm hoping they shouldn't be too expensive. I know aftermarket carbon covers don't come with the metal parts hence the post. If they're cheap enough, I'll get a small number made and put them on the Bay - you never know

[Blackal]

I think I have six of those plates........
.
.
.
.
.
.
.
.
But they are all attached to the original CF covers.

(Good initiative, though )